I'm pulling my hair out over this because I don't know enough to be able to fix it! Oh no, not your hair. The graph description query is ' host_description - Traffic - query_ifName ' and as you can tell from the data source name, it correctly identifies host_description as 'Netgear L2 Switch' but for some reason doesnt like query_ifName. The datasources of my other devices are specific to the query results of those devices which leads me to believe there is an issue here with the interface query used by the graphing template. Once the graphs are created and if I look at the properties of them, the inbound and outbound data sources are listed as 'Netgear L2 Switch - Traffic - query_ifName (traffic_in)' and 'Netgear L2 Switch - Traffic - query_ifName (traffic_out)' respectively. When creating the graphs, the Data Query (SNMP - Interface Statistics) successfully IDs the ports on the switch: Index Status Description Name (IF-MIB) Type Speed Hardware Address 1 Up Unit: 0 Slot: 0 Port: 1 Gigabit - Level 0x72240000 Unit - 0 Slot - 0 Port - 1 gigabitEthernet(117) 00:00:0F:B5:4B:A0:65 2 Up Unit: 0 Slot: 0 Port: 2 Gigabit - Level 0x72240000 Unit - 0 Slot - 0 Port - 2 gigabitEthernet(117) 00:00:0F:B5:4B:A0:66 Etc. = I apologize ahead of time for my scripting n00bness! I am trying to monitor the ports on our Netgear switches however the graphing query can't resolve the interface name as the datasource so no graphs get generated (I am only guessing this is the problem from my deductions below). Is there any Netgear specific host or graphing script(s) that would resolve the issue below? I don't want any of the developers or gurus wasting their time if someone has already developed a script to take care of this. You can use Cacti to graphically plot your interfaces. If you can edit your question with the specific model of Netgear switch. And choose Cisco Router as host template.
MANUAL ARCTIC CIRCLE MODELO P 600 HOW TO
Show you how to enable and configure SNMP in the Cisco switch/router. GS748TS GS724TS, monitored with Cacti via SNMP. Posts: 427 Location: UK Well, I was able to figure out the sysDescription is FS700TS Switch and that the. Anyone know if mactrack is compatible with netgear switches (eg FS700TS. 7 and a GS716Tv3 Netgear switch firmware 6.3.1.11.
0 kommentar(er)
